MTP usage for a SIP trunk

[cterpreau]

Hello, i have configured mtp gw's to be used with a SIP trunk but how can i check on the mtp gw itself that it is used by the trunk ??

Cheers.

[nitsinha]

Hi,

Try the following command

show sccp connections

Use this command to verify the active SCCP connections, for example:

Router# show sccp connections

sess_id    conn_id    stype mode     codec   ripaddr         rport sport

16777268   2164263392 mtp   recvonly g711u   0.0.0.0         0     17540

Total number of active session(s) 1, and connection(s) 1

ripaddr=Remote ip address
rport=Remote port
sport=source port

HTH

Regards
Nitesh

PS:Pl rate helpful posts