Need help on voice translation rules

[Rupesh Kshirsagar]

Hi all,

I have small CME setup and i want to translate the 111 to 09821444335. If some one dial 111 its convert to 09821444335.

so following rule i configured in router but its not working. pls help

voice translation-rule 1

rule 1 /1111/ /09821444335/

!

!

voice translation-profile profile1

translate calling 1

dial-peer voice 2 pots

description OUTGOING-CALLS

translation-profile outgoing profile1

destination-pattern 0T

port 0/0/0:15

Thanx in advance..

[Andrey Chertolyas · Accepted solution]

Hi Rupesh,

You should change 'translate calling' to 'translate called' in your voice translation-profile in order to change B-number. Also you have to change destination-pattern string to ^111$ since translation-profile applies after the call matches the dial-peer. You can use num-exp command in global configuration instead of using voice translation-profiles but I'd recommend to use tp's since they are much more flexible than num-exp command.

Also I have noticed that you are using four 1s in your translation-rule while referring to three 1s in your description, please check it.

Kind regards,
Andrew C.

[islam.kamal · Accepted solution]

Hi

In addition to the perfect explanasion of Mr/Andrew. Please find the below to configure the num-exp and ignore translation rule.

num-exp 111 09821444335

dial-peer voice 10 pots

destination-pattern 111

port 0/0/0:15

Num-exp happens BEFORE dial-peer matching, they would have a higher precedence than any translation profiles applied to your dial-peers .
Cisco gateway will take the digits a user dialed and apply any  matching number-expansions before looking to match outbound dial-peers  so the number-expansion takes priority

Thank you

please rate all useful information

[Rupesh Kshirsagar]

Thanks Guuyis its work with num-exp command..