08-17-2009 12:45 AM - edited 03-15-2019 07:23 PM
Recently, I have intsalled a new IOS on a cisco router. It was cm2800nm-advipservicesk9-mz.124-22.YB.bin and now is advipservicesk9-mz.124-24.T.bin
After some time I have noticed what all new phones are not able to load a firmware. If I resert old phone it is now loading a firmware as well.
I know what for IP phone 7940 I should use next files:
term42.default.loads
jar42sccp.8-4-1-23.sbn
cnu42.8-4-1-23.sbn
apps42.8-4-1-23.sbn
dsp42.8-4-1-23.sbn
cvm42sccp.8-4-1-23.sbn
I checked flash area and found all of them.
After upgrading I see a screen with a cisco logo and nothing happens after that.
And it is also looked like phone is trying to upload a firmware from wrong tftp server.
Any help how to fix it would be appreciated.
Solved! Go to Solution.
08-17-2009 04:30 AM
You are missing a .loads file and have to refeence that as "load" under telephony-service.
08-17-2009 04:30 AM
You are missing a .loads file and have to refeence that as "load" under telephony-service.
08-17-2009 05:45 AM
it works after I applyed next steps:
SUMMARY STEPS
1. enable
2. configure terminal
3. tftp-server device:firmware-file
4. telephony-service
5. load phone-type firmware-file
6. create cnf-files
7. end
But I still quet dont understand why after upgade it stoped working.
08-17-2009 07:37 AM
With new software, you can eliminate all the the tftp-server commands, just use .loads extension and cnf location flash:/
Thanks for the nice rating and good luck.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide