NIC Teaming MCS 7825-H2 Unified CallManager 5.x

[Eric Krieger]

Upto now I couldn't find information about NIC Teaming on a CallManager 5.x platform, except that it is supported.

Is it enabled by default? If not, is there a description available how to enable and how use it?

Thanks,

Eric

[msolak · Accepted solution]

eric,

you can do this with ccm cli. have a look at this link:

http://www.cisco.com/en/US/products/sw/voicesw/ps556/products_administration_guide_chapter09186a00806c3e25.html#wp1011080

"set network failover enable" only NFT.

regards

mehmet

[Alfredo Naranjo]

mehmet

I have upgraded CallManager 5.0.2 to 5.0.4 so I would like to know if I can enable network failover

Regards

Alfredo

[thisisshanky]

Alfredo, No difference in the way NFT is done in 5.0 or 5.1. Use the same command "set network failover enable" from CLI.