10-03-2012 06:52 PM - edited 03-16-2019 01:30 PM
Hi all,
I got a New CTS system, and I configure it for call using IP's and a VCS, Then, I decide to register it to the call manager and I follow these instructions.
https://supportforums.cisco.com/thread/2172240
I got it registered and usng the web interface, but I decide to do a restart, and now I am no longer be able to see anything in the explorer, I saw there was a option "enable web access", it as as "disable", so I though enableing it would let me access to the configurations explorer.
BUT, I change the option, put "save" ans then "reset" (as it says on the manual).
The device registers it again, but Im still not be able to web access it.
I'be tried to disable it --> reset --> enable it --> reset... the device does reset but with no web access.
Please can you help me with this?
And this is the configuration I use to register.
Also I've tried to SSH2 it, and no luck.
please help me
Call Manager Version:
8.1.6-20000, (the firmware the device has, it is the original, no upgraded after registered).
regards
More Information
(No web access either Firefox or IE)
11-02-2012 08:44 AM
Well I solved this, I just use the Remote Control of the CTS and I enable again the web access.
5 start for me
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide