cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
726
Views
0
Helpful
3
Replies

NTP server error

Hi All

I have problem in NTP server I configured my Domain server as ntp server when add the ntp server in the cucm 7 Pub by ip of my domain server (192.168.1.7)  the status showing  "The NTP service not accessible".

I login the ssh to the call mamager server ssh

admin:utils ntp status

ntpd (pid 19919) is running...

     remote           refid      st t when poll reach   delay   offset  jitter

==============================================================================

127.127.1.0     LOCAL(0)        10 l   63   64    1    0.000    0.000   0.004

192.168.1.7     .INIT.          16 u    -   64    0    0.000    0.000 4000.00

unsynchronised

  time server re-starting

   polling server every 64 s

Current time in UTC is : Sun Oct 27 12:25:19 UTC 2013

Current time in Asia/Riyadh is : Sun Oct 27 15:25:19 AST 2013

Thanks

3 Replies 3

islam.kamal
Level 10
Level 10

Hello

Abdo , if you use Windows as NTP server , there is a problem to synchronize with Cisco CUCM linux OS.Please find the below link

http://tools.cisco.com/Support/BugToolKit/search/getBugDetails.do?method=fetchBugDetails&bugId=CSCte17541

Thank you

Please rate all useful information

Hi

It is recommended to use IOS devices as routers , as your gateway. Please find the below config;-

ntp master 1

ntp source loopback 0

ntp server X.X.X.X

clock timezone SA ( )

clock summer-time SA recurring

Then on your CUCM- OS - add ntp -use the Ip address of your looback

Thank you

Please rate all useful information

Aman Soi
VIP Alumni
VIP Alumni

Hi Ahmed,

Please refer these link which was discussed recently

https://supportforums.cisco.com/message/4072574#4072574

regds,

aman

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: