PRI Outbound calling question

[omgjames1]

Let me give me a a brief description of the set up

H. 323, PRI's are at both locations and an 220mb Opti-Man fiber connects the two sites. Call Manager 7.1.3 and Unity Connections 8.6.2

If the PRI at one location goes down, internal calling still works fine. I know I can make outbound calls at the downed site, but i am not sure what command needs to go on the rempote gateway to allow this.

[Leonardo Santana]

You can put another route group inside your route list, for backup!

Like the example you can multiple call routing choices!

http://www.cisco.com/en/US/docs/voice_ip_comm/cucm/srnd/8x/dialplan.html#wp1044260

Regards

Leonardo Santana

Rate this if helps!

[omgjames1]

can you please give me an example of what the command might look like?

[Leonardo Santana]

See the example above!

[omgjames1]

o geeze sorry, I was viewing your previous answer in my email and the diagram wasnt showing up.

[Leonardo Santana]

Ok, take a look on the CUCM SRND!

Route Patter ->> RL ->>> RG1, RG2

Inside the route group you have the devices that yoy wanna route the call!

Rate this if helps!

Regards

Leonardo Santana!