Guys,
I'm really thinking this is a Telco issue but I'd like to get your thoughts on this.
On a 3945, I'm receiving a huge amount of RTMT alerts about a PRI going up and down a lot. The Show controller t1 ouutput show a lot of errors:
T1 0/0/0 is up.
Applique type is Channelized T1
Cablelength is long 0db
Description: Circut ID XXXXXXXXXXX
No alarms detected.
alarm-trigger is not set
Soaking time: 3, Clearance time: 10
AIS State:Clear LOS State:Clear LOF State:Clear
Version info FPGA Rev: 08121917, FPGA Type: PRK4
Framing is ESF, Line Code is B8ZS, Clock Source is Line.
CRC Threshold is 320. Reported from firmware is 320.
Data in current interval (433 seconds elapsed):
0 Line Code Violations, 3714 Path Code Violations
4 Slip Secs, 53 Fr Loss Secs, 0 Line Err Secs, 0 Degraded Mins
156 Errored Secs, 74 Bursty Err Secs, 4 Severely Err Secs, 49 Unavail Secs
Total Data (last 24 hours)
8467 Line Code Violations, 443834 Path Code Violations,
2437 Slip Secs, 7480 Fr Loss Secs, 259 Line Err Secs, 54 Degraded Mins,
19839 Errored Secs, 8507 Bursty Err Secs, 403 Severely Err Secs, 7576 Unavail Secs
T1 0/0/1 is down.
Anything else I need to look at?
Any help would be appreciated!
Gareth
