Problem with FXO card

[cvicentep]

Hi, i have a CCM 6 and Unity Connection 2.0 with IVR,all work fine, but i try to connect the lines of the old PBX to FXO card, but when i try to call the line ringing but dont send to IVR.

This is part of the configuration

voice-port 0/2/2

timeouts call-disconnect 2

connection plar opx 3022

description Linea 3265323

caller-id enable

This gateway is configured in H323

Thanks regards,

Carlos

[Jaime Valencia]

do you already have a dial peer for 3022 and that DN configured in CUCM to go to VM??

HTH

javalenc

if this helps, please rate

[cvicentep]

The configuration of dial-peer is :

dial-peer voice 550 voip

destination-pattern *32T

session target ipv4:172.16.4.1

incoming called-number ....

dtmf-relay h245-alphanumeric

codec g711alaw

ip qos dscp cs5 media

[Jaime Valencia]

does it work if you change it to?:

destination-pattern 32..

HTH

javalenc

if this helps, please rate

[cvicentep]

i change taht and nothing.

but i execute this comand :

GW#sh voice port 0/2/2

Foreign Exchange Office 0/2/2 Slot is 0, Sub-unit is 2, Port is 2

Type of VoicePort is FXO

Operation State is DOWN

Administrative State is UP

The Last Interface Down Failure Cause is Administrative Shutdown

Description is Linea 3265323

and appear that.

[Jaime Valencia]

then go to voice port config and do a shut / no shut

HTH

javalenc

if this helps, please rate