Hi there. We are currently running cm 6.x, but are in the middle of an upgrade to 8.x. meanwhile I have to keep the old system running. Yesterday we had a pub failure, and all our agents were unable to log in because the 'services' button wasnt working. I figure "no problem" and go to the sub, enterprise parameters and change the services url to be the address of the sub. No can do. Cant make changes to the sub, only the pub can and of course that was in flames, never to be resurrected again.
So my question is, how do I make the services url be failover as well? DNS? (ouch) other?
This document is intended to receive any new ideas for TAC to create new useful walkthrough videos to help set up deployments, integrations, etc.
Feel free to share any feedback about new walkthrough videos you consider useful, please share your o...
Configuring Cloud Connected PSTN (CCP) – Easy as 1-2-3!
STEP 1: PREPARE
Before you can configure your CCP in Control Hub, you must procure PSTN services from an authorized Webex Calling CCP Partn...
To participate in this event, please use the button to ask your questions
This topic is a chance to discuss more about how to read Cisco Unified Communications trace files. In this session, Cisco D...