Hi All,
I have calls coming via SIP trunk in a 2611xm router that has 4 FXO lines for dialing out to campus exchange. The setup is working for both inbound and outbound calls. Users are dialing a standard pattern e.g. XXXX , 9XXX XXXX etc.
Now is there a way to restrict incoming SIP call i.e. from the calling number e.g. 1000 to go out via a specific FXO port, while rest of the the calls should go out via remaining 3 FXO ports.
Thanks
-Azher
Current Config:
>>>> Four Analog FXO
voice-port 1/0/0
input gain 10
no comfort-noise
connection plar 8000
caller-id enable
!
voice-port 1/0/1
input gain 10
no comfort-noise
connection plar 8000
caller-id enable
!
voice-port 1/1/0
input gain 10
no comfort-noise
connection plar opx 8898
!
voice-port 1/1/1
input gain 10
no comfort-noise
connection plar opx 8000
!
>>>> Dial-Out
!
dial-peer voice 3 pots
description Dialout via 3862
destination-pattern .
incoming called-number .
port 1/0/0
!
dial-peer voice 4 pots
description Dialout via 3015
preference 1
destination-pattern .
incoming called-number .
port 1/0/1
!
dial-peer voice 5 pots
description Dialout via 8797
preference 2
destination-pattern .
incoming called-number .
port 1/0/1
!
dial-peer voice 10 pots
description Dialout via 8898 for User-X <<<< Restriction Required
preference 3
destination-pattern .
incoming called-number .
port 1/1/0
!
sip-ua
retry invite 3
retry response 3
retry bye 3
retry cancel 3
timers trying 1000
sip-server ipv4:10.10.10.1
!
>>> Incoming calls via POTS to SIP Server
dial-peer voice 2 voip
preference 1
destination-pattern 8...
progress_ind setup enable 3
session protocol sipv2
session target ipv4:10.10.10.1:5060
session transport udp
dtmf-relay rtp-nte
codec g711ulaw
no vad
