RightFax config for 2911 router and Call Mgr

[Yort Mantup]

Hello,

I am trying to configure a POTS line running to an FXO port on a 2911 router.  Currently when i test I get connection (no tones) then the call drops.  My path is PSTN --> FXO --> CM (mgcp) -- RightFax.  I have a route pattern for the number pointing to a trunk configured for connection to RightFax.

Router - 2911 running 15.0(1)MS

Call Manager 8.5

I have enabled T.38 and the appropriate commands and dial peers.  At least to my knowledge.  I attached the mgcp, voiceport and dial-peer config below.  Looking for some advice as to what I may be missing. 

[Sven Ravenstein]

Hello,

you are calling from external into your mgcp gateway to the faxserver?

Is the Faxserver connected to fxo port 0/2/1 ?

The gateway is properly registered?

Regards,

Sven

[Yort Mantup]

Yes that is correct.  I found the issue late yesterday.  My device pool in Call Manager was not configured correctly.  I now have this working.