I have two branches in differents countries connedted using WAN Interfaces.
SIDE A wants to call local numbers located on SIDE B so I want these numbers come out on Gateway SIDEB but I want my normal users use the international number.
For example if I want my normal users calls on SIDE A call to SIDE B they should dial 001 305 and the rest of the number. So it it really necessary on my Router Pattern I use /+1 and the rest of the number? or I can just use 001 and the rest of number?
I don't know if this /+ influences something on CUCM or Gateway?
There are multiple ways to do this but you’re asking a question that has more than a hundred pages dedicated to it in the SRND; it’s difficult to explain succinctly on a forum thread.
I suggest reading up on global dial plans in CUCM. The underlying principal is to “act local, think global.” Which is to say: accept localized input appropriate to the calling party’s location (eg 001), globalize that into a consistent/predictable pattern (ie +<country code>) and _then_ decide where to route the call. If the pattern leads off-net _and_ the carrier doesn’t accept +E.164 formatted-numbers (most SIP trunks do, not ISDN though) re-localize the number down at egress to what that carrier expects. Admittedly, there are countries where this can be annoying to configure, especially those where cell phones have an extra digit but are mixed in with land lines (eg Japan). This site is a good reference for national dialing plans: https://www.itu.int/oth/T0202.aspx?parent=T0202
Hello, We have been facing issues with backup of drfcomponent.XML & Processnode.XML files to our backup servers during scheduled Backup in our CUCM 11.0 servers.We have been using Titan FTP server for Backup. I see error on backup statusERRO...
To participate in this event, please use the button to ask your questions
At the beginning of 2020, no one would have imagined the changes in work and learning habits that we would face in the foll...
We have a manager that's left and we want to let callers know to call the new manager at a different number, but we don't want the caller to be able to leave a message. Can a voicemail box be setup to work this way?If so, how? Thanks Kelvin
Hi We have CM 11.5 and jabber 12.6 some of our users are receiving incorrect user name or password login, we can confirm the credentials are correct, not all of them are facing the issue some of the users are able to login while others get the ...