SCCP phones have correct time format but SIP Phone have a wrong time zone and incorrect date format

[jchevalon]

Hello,
I currently have about twenty phone SCCP
And one SIP phone

I have an ISR2901, CME 10.5. , and I have set up an NTP

All SCCP phones have the correct date format, and the correct time.

My SIP Phone is registered, all work perfectly.

The only concern I have is the time.

I used unsuccessfully these links:

- https://supportforums.cisco.com/discussion/11717026/clock-sip-phone-3905

- http://www.cisco.com/c/en/us/td/docs/voice_ip_comm/cucme/troubleshooting/guide/ts_time.html

I followed the links above and here where I am for Voice Register Global:

voice register global
 mode cme
 source-address 192.168.5.60 port 5060
 max-dn 200
 max-pool 42
 tftp-path flash:
 create profile sync 4321001012373626
 ntp-server 192.168.5.60 mode directedbroadcast

NTP server is my CME (192.168.5.60) , i am in Switzerland and i have try too with NTP on this site: http://www.pool.ntp.org/zone/ch whithout success.

I did with and without, it's the same thing.

I made a create profile after each of these tests

thanks in advance for your help

[Vivek Batra]

Didn't you try with configuring timezone command under voice register global?

- Vivek

[jchevalon]

Hi Vivek,

I have try but i have "invalid input" each time, I can not get it directly on "voice register Global"

I get can not be properly understand the syntax.

My time zone is:

CEST	Central Europe Summer Time, as UTC + 2

[Vivek Batra · Accepted solution]

I believe that indexing has not been changed in the later revision.... if so, configure it as follows;

timezone 28

You simply need to configure the timezone 'index'. In the version I've, it's 28 for CEST (UTC + 120/mins).

- Vivek

[jchevalon]

Its ok now concerning the time, its correct 

but it is the 12h time format and mm/dd/yyyy

I would like to it to be:
24h time formats and dd / mm / yyyy

Do you know how i can set up it?

[Vivek Batra · Accepted solution]

Good...

time-format 24

date-format D/M/Y

Don't forget to give 'create profile' command and restart the phones.

- Vivek

[jchevalon]

Great, 

its work.

Thank you again!!

[Vivek Batra]

You're most welcome!

- Vivek