Secondary dial tone issue

[SJ SJ]

I wanted to confirm that do we get secondary dial tone  on analog phone connected to cisco voice gateway through fxs and  the gateway is connected to pbx (Nortel Meredian option 11 c)  thorugh E1.

Regards

[Payal Bhaduri]

we can get a secondary dial-tone on fxs if the voice gateway is an MGCP gateway

[SJ SJ]

Is there any way we can give a secondary dial tone when

anlaog phone is connected to Gateway on fxs and the Gateway(h323)  is connected to PBX through E1.

[analog phone -> GW -> PBX]

Regards

[Payal Bhaduri]

For an FXS connected device, the FXS port provides (initial) dial tone. There is no

facility within the FXS to provide secondary dial tone. The only way that you can provide

secondary dial-tone is to look at MGCP Gateways, and allow CCM to provide the secondary

dial-tone.

[Payal Bhaduri]

Is this a CME?

[Payal Bhaduri]

If this is a CME,

the secondary dial-tone can be configured using the

telephony-service

secondary-dialtone 9

[SJ SJ]

Thnx Payal,

This is not CME. It means there is no way to provide secondary dial tone in my scenario.

Regards