cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
944
Views
0
Helpful
0
Replies

Cisco 2901, Sip - ISDN 30 Call forwarding will not work.

leebyatt1980
Beginner
Beginner

Hello,

We have a cisco 2901 which is connected into a SIP vendor and then converts to ISDN 30 which uplinks into a traditional PaBX system.

Internal calls work absolutly fine as well as external calls.

The issue comes when we happen to set a call forward on the Pabx, the party calling in recieives busy tone.

Looking at the trace it is because their is no diversion header but the telephone system is passing on the calling CLI which is not allowed on the trunk.

Speaking to the vendor involved they state we need to change the FROM field in the header.


I cannot see a resolve with the config, however I was wondering if any one could advice what I have done wrong.

Many thanks.

0 Replies 0
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: