Hi All, I have an exciting CME on a 2921 router. I want to have a separate POTS line that will come into an FXO port and then the final destination will be a 7965 IP phone. I have setup a separate COR so that this phone will not be able to make outbound calls on the other existing FXO ports and the inbound FXO should only come in on the 7965.
Does this config look correct? Any better way of accomplishing this?
***Class of Restriction***
dial-peer cor list Separate-phone
member Separate-phone
***Voice Port POTS***
voice-port 0/0/0
connection plar opx immediate 6000
description POTS Line for seperate phone
caller-id enable
***Dial Peer***
dial-peer voice 10 pots
corlist outgoing Separate-phone
description ** Forward all Digits **
destination-pattern 8T
port 0/0/0
forward-digits all
***Users DN***
ephone-dn 11 dual-line
number 6000
corlist incoming Separate-phone
