I have configured shared line for SIP
The issue I am getting is that when I enable shared-line command in dn. User is no longer able to answer incoming call to both device. (headset, speaker button or software button)
Call just keep ringing.
Specify Shared-line max-call does not make any difference
Any idea?
voice service voip
ip address trusted list
ipv4 x.x.x.x
mode border-element license capacity 10
allow-connections sip to sip
no supplementary-service sip moved-temporarily
no supplementary-service sip refer
fax protocol t38 version 0 ls-redundancy 0 hs-redundancy 0 fallback pass-through g711ulaw
modem passthrough nse codec g711ulaw
sip
bind control source-interface GigabitEthernet0/0/0
bind media source-interface GigabitEthernet0/0/0
registrar server expires max 600 min 60
asserted-id pai
midcall-signaling passthru media-change
early-offer forced
!
!
voice register dn 14
number 7065
call-forward b2bua busy 5000
call-forward b2bua noan 5000 timeout 30
allow watch
name Peter
label Peter
shared-line
mwi
!
voice register pool 28
busy-trigger-per-button 2
id mac AAAA.BBBB.CCCC.DDDD
type 7841
number 1 dn 14
cor incoming user-International default
presence call-list
dtmf-relay rtp-nte cisco-rtp sip-notify
username U28 password A12345z
no vad
!
voice register pool 28
busy-trigger-per-button 2
id mac AAAA.BBBB.CCCC.DDDD
type 7841
number 1 dn 14
cor incoming user-International default
presence call-list
dtmf-relay rtp-nte cisco-rtp sip-notify
username U28 password A12345z
no vad