Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello, I would need help with having CM working as an external directory for CME. I have tried the official documentation with no success. I found information about some workaround but a lot of thread leads to page not found so dead end on this.I am ...
I have configured shared line for SIP The issue I am getting is that when I enable shared-line command in dn. User is no longer able to answer incoming call to both device. (headset, speaker button or software button)Call just keep ringing.Specify S...
Basically I am unable to sync Unity with CUCME since that I have found out that cisco has removed "web admin" in new IOS. Cisco IOS XE Gibraltar 16.11.1a ReleaseUnified CME 12.6The command is deprecated. It is not supported on Unified CME 12.6 and la...
Hi, I have a Sip trunk configured behind a Meraki MX doing NAT and I have been through a lot a issue since the beginning. I had to apply some Sip header configuration found on internet from another Sip provider resulting incoming call working but nev...
Hi, I am wondering if anyone has the same issue.Based on information I found on mutliple forum.I have added mac address of phones from CME to CUCMI did reset CUCM phones.Still no success, it seems to connect to directory but I have 0 contact foundDo ...
Just to follow up this post with solution that worked for me. sip header FROM modification was the solution but I had to tweak formula to replace the user directory number displayed in the screenshot by the clid network number for Gamma to accept cal...
Spoiler Hi, thanks for you help I really appreciate it. Unfortunately this has not fix the problem I have tried to modify sip header and it does not seem to do any result with debugThere is a screenshot of what provider receive and in yellow that is...
