05-18-2012 06:21 AM - edited 03-16-2019 11:14 AM
Dear NetPro gurus,
My clients 7945G SIP Phones managed to get the DN from the CME Router, however, it is stuck on "registering" stage and when i do the debug tftp packets & debug tftp events, it always say it can't find the .tlv file.
I have attached my configs and debug in the attached file.
Cheers,
Hunt
05-18-2012 06:36 AM
Do do note use SIP with CME.
Convert to SCCP and it will work fine.
05-18-2012 06:43 AM
Has this phone previously register to a CUCM cluster before? It looks like the phone has downloaded both ITL files and CTL files. You will need to erase those files or do a factory reset
05-18-2012 05:22 PM
I did a factory reset by holding down the # button followed by 1 2 3 4 5 6 7 8 9 * 0 #, the phone reboots but gets the SIP Phone image again.
THe phone may have registered to CUCM before. How can i erase both ITL and CTL and let it starts from beginning?
05-18-2012 11:01 PM
In cme config, specity an SCCP load.
Then do the atotal lternate sequence 3491672850*#
05-19-2012 03:54 AM
THanks Paolo. I will give that a try tomorrow.
Just a side question, so SIP Phones can't register with CME?
05-19-2012 04:07 AM
Hunt Lee,
SIP phones can register with CCME they just dont work as good as SCCP phones. If you set up your system correctly your SIP phone should register
05-20-2012 05:11 AM
Hi Aokaniawon,
So what could i be missing that stop the SIP phones from working? My clients really want to use SIP. Do you have any ideas?
Would greatly appreciated any help you can provided.
Cheers,
Hunt
05-20-2012 06:48 AM
Since you did a factory reset, what do you get when the phone attempts to register..
can you plug the phone in and send a
'debug tftp events' and
sh telephony-service tftp-bindings
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide