cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
3824
Views
5
Helpful
12
Replies

SIP Trunk One way audio issue

anishktr2005
Level 1
Level 1

Dear Team,

 

      I have a sip trunk between cisco UCM to Huwaei escape PABX,sip trunk between cisco to huwaei is up and call are going,but i am facing one way voice issue,98% calls i an facing the same audio issue.

Huwaei extension can hear my voice from cisco phone,but i cant hear voice from huwaei extension.

Any one please reply

 

 

 

1 Accepted Solution

Accepted Solutions

The Cisco CallManager logs are needed: How to Collect Traces for CUCM 9.x, 10.x and 11.x

Georgios
Please rate if you find this helpful.

View solution in original post

12 Replies 12

Georgios Fotiadis
VIP Alumni
VIP Alumni

Is there a firewall between Cisco IP Phones (or CUCM) and the Huawei PBX? Can you attach SDL logs from CUCM for a specific call?

Georgios
Please rate if you find this helpful.

There is no firewall between both system,can you please tell me how to take SDL logs from CUCM

The Cisco CallManager logs are needed: How to Collect Traces for CUCM 9.x, 10.x and 11.x

Georgios
Please rate if you find this helpful.

i am getting this error while i am tracing

i am getting this error while i am tracing

First make a call and then gather CallManager logs for the last xx minutes.

Georgios
Please rate if you find this helpful.

here is the sdl log

Please find the attached SDL LOG

 

Huwaei Extension-7612

Cisco Extension-3466

 

Thaks for your support

attached sdl log

Hello bro!, are you using a CUBE? it´s just that i see the following

 

CUCM 10.222.0.11

IP Phone 10.222.0.115

direct INVITE to "213.34.194.102"

 

Regards

Alexis

Dear Alexis,

There is no CUBE in between,this is only connection between CUCM TO Huwaei PBX

Regards
Anish

Stan2
Level 1
Level 1

Please try to enable MTP (Media Termination Point) checkbox in Trunk Configuration settings on CUCM. This helped me.