Swapping an MGCP Gateway to H323

[j.rodriguez.hormigos]

Hi mates,

I need to change one of my voice devices to H323 configuration.

Time ago, I had a Cisco guide to change a gateway running MGCP to H323, but now I don´t find this guide. The title of this document I remember was Configuring a H323 gateway from MGCP.

If you know, please can you tell me if this guide continues in CCO, and if so, where can I find it.

Many thanks to all in advance.

Really appreciated.

PRO

[Payal Bhaduri]

We need to remove the configuration for MGCP GW and then add configuration for H.323.

To remove the MGCP GW from CM, please delete this GW in "Device" - "Gateway". To disable
MGCP in GW, please use "mo mgcp".

To add a H.323 GW, please refer to the following link.

Here's the steps to add a H.323 GW in CM:
http://www.cisco.com/en/US/docs/voice_ip_comm/cucm/admin/4_2_3/ccmcfg/b06gtway.html#wp1311511

Here's the description for different parameters:

http://www.cisco.com/en/US/docs/voice_ip_comm/cucm/admin/4_2_3/ccmcfg/b06gtway.html#wp1312420

Here's the configuration guide to enable H.323 function and add dial-peer in GW:
http://www.cisco.com/en/US/docs/ios/12_3/vvf_c/cisco_ios_h323_configuration_guide/old_archives_h323/4gwconf.html

[j.rodriguez.hormigos]

Hey Payal.

Many tks for your quick answer.

I knew these links, I meant to a guide (was only a document, including best practices) where step by step the change to H323 were explained.

My CM version is 5.1.3.

Regards,

PRO