- last edited on by
ciscomoderator
I have an issue, I'm getting a fast-busy when I call from 555-6002 to 555-5028. Where am I going wrong with this?
- Calls work from 555-6002 to 555-5000
- Calls work from 555-5028 to 555-6002
- Calls Fail from 555-6002 to 555-5028
ephone-dn 1 dual-line
number 5000 secondary 5555000
name Sara Driscoll
dial-peer voice 1 pots
destination-pattern 5555028
port 0/3/1
!
dial-peer voice 3 pots
incoming called-number 5555...
direct-inward-dial
port 0/2/0:23
!
dial-peer voice 2 pots
destination-pattern 555[4,5,6]...
port 0/2/0:23
forward-digits all
FULL CONFIG
! Last configuration change at 15:12:39 UTC Tue Sep 30 2014
version 15.1
service timestamps debug datetime msec
service timestamps log datetime msec
no service password-encryption
!
hostname RouterVOIP1
!
boot-start-marker
boot-end-marker
!
!
card type t1 0 2
!
no aaa new-model
!
memory-size iomem 5
network-clock-participate wic 2
!
dot11 syslog
ip source-route
!
!
ip cef
!
ip dhcp excluded-address 10.15.0.1 10.15.0.10
!
ip dhcp pool Voice
network 10.15.0.0 255.255.255.0
default-router 10.15.0.1
option 150 ip 10.15.0.1
!
!
no ipv6 cef
!
multilink bundle-name authenticated
!
!
!
!
isdn switch-type primary-ni
!
!
!
!
!
!
!
voice-card 0
!
crypto pki token default removal timeout 0
!
!
!
!
license udi pid CISCO2811 sn FTX1151A3PR
username class privilege 15 password 0 cisco
!
redundancy
!
!
controller T1 0/2/0
cablelength long 0db
pri-group timeslots 1-8,24
!
!
!
!
!
!
!
!
!
interface FastEthernet0/0
no ip address
duplex auto
speed auto
!
interface FastEthernet0/0.1
encapsulation dot1Q 1
ip address 10.1.0.1 255.255.255.0
!
interface FastEthernet0/0.10
encapsulation dot1Q 10 native
ip address 10.10.0.1 255.255.255.0
!
interface FastEthernet0/0.15
encapsulation dot1Q 15
ip address 10.15.0.1 255.255.255.0
!
interface Service-Engine0/0
no ip address
shutdown
!
interface FastEthernet0/1
ip address 172.20.0.1 255.255.255.0
shutdown
duplex auto
speed auto
!
interface Serial0/0/0
no ip address
shutdown
no fair-queue
clock rate 2000000
!
interface Serial0/0/1
no ip address
shutdown
clock rate 2000000
!
interface Serial0/2/0:23
no ip address
encapsulation hdlc
isdn switch-type primary-ni
isdn incoming-voice voice
no cdp enable
!
!
router eigrp 100
network 10.0.0.0
!
ip forward-protocol nd
ip http server
ip http authentication local
no ip http secure-server
!
!
!
!
!
!
!
!
tftp-server flash:CME_8.6/cmterm-7940-7960-sccp.8-1-2/P00308010200.bin alias P00308010200.bin
tftp-server flash:CME_8.6/cmterm-7940-7960-sccp.8-1-2/P00308010200.loads alias P00308010200.loads
tftp-server flash:CME_8.6/cmterm-7940-7960-sccp.8-1-2/P00308010200.sb2 alias P00308010200.sb2
tftp-server flash:CME_8.6/cmterm-7940-7960-sccp.8-1-2/P00308010200.sbn alias P00308010200.sbn
tftp-server flash:CME_8.6/ringtones/DistinctiveRingList.xml alias DistinctiveRingList.xml
tftp-server flash:CME_8.6/ringtones/RingList.xml alias RingList.xml
tftp-server flash:CME_8.6/ringtones/Jamaica.raw alias Jamaica.raw
tftp-server flash:CME_8.6/music-on-hold.au alias music-on-hold.au
tftp-server flash:CME_8.6/ringtones/Classic1.raw alias Classic1.raw
tftp-server flash:CME_8.6/ringtones/Drums1.raw alias Drums1.raw
tftp-server flash:CME_8.6/ringtones/Piano1.raw alias Piano1.raw
tftp-server flash:CME_8.6/ringtones/KotoEffect.raw alias KotoEffect.raw
tftp-server flash:CME_8.6/ringtones/AreYouThere.raw alias AreYouThere.raw
!
control-plane
!
!
voice-port 0/2/0:23
!
voice-port 0/1/0
ring number 2
!
voice-port 0/1/1
!
voice-port 0/3/0
!
voice-port 0/3/1
!
voice-port 0/3/2
!
voice-port 0/3/3
!
!
!
mgcp profile default
!
!
dial-peer voice 1 pots
destination-pattern 5555028
port 0/3/1
!
dial-peer voice 3 pots
incoming called-number 5555...
direct-inward-dial
port 0/2/0:23
!
dial-peer voice 2 pots
destination-pattern 555[4,5,6]...
port 0/2/0:23
forward-digits all
!
!
!
!
telephony-service
max-ephones 10
max-dn 40
ip source-address 10.15.0.1 port 2000
load 7960-7940 P00308010200
keepalive 10
max-conferences 8 gain -6
transfer-system full-consult
create cnf-files version-stamp Jan 01 2002 00:00:00
!
!
ephone-dn 1 dual-line
number 5000 secondary 5555000
name Sara Driscoll
!
!
ephone-dn 2 dual-line
number 5001
name Jenny Parker
!
!
ephone 1
device-security-mode none
mac-address 001F.6C7F.973B
button 1:1
!
!
!
ephone 2
device-security-mode none
mac-address 001F.6C80.FDE9
button 1:2
!
!
!
!
line con 0
logging synchronous
line aux 0
line 194
no activation-character
no exec
transport preferred none
transport input all
transport output lat pad telnet rlogin lapb-ta mop udptn v120 ssh
line vty 0 4
login
transport input all
!
scheduler allocate 20000 1000
end
Accepted Solutions
Thank you for the reply and trying to help me out, I really appreciate it. I"m still racking my brain.
Based on the commands below it seems the dial-peers are okay. I wonder if its the T-1, but that appears okay too.
lobal ISDN Switchtype = primary-ni
ISDN Serial0/2/0:23 interface
dsl 0, interface ISDN Switchtype = primary-ni
Layer 1 Status:
ACTIVE
Layer 2 Status:
TEI = 0, Ces = 1, SAPI = 0, State = MULTIPLE_FRAME_ESTABLISHED
Layer 3 Status:
0 Active Layer 3 Call(s)
Active dsl 0 CCBs = 0
The Free Channel Mask: 0x800000FF
Number of L2 Discards = 0, L2 Session ID = 3
Total Allocated ISDN CCBs = 0
Carlo, thank you for your reply. That helped me out a great deal. When debugging "debug voice ccapi inout" it yielded no results which had me thinking...that isn't right.
Through further investigation I found that the PBX was to blame "Bad Adtan PBX!"
I'll raise the issue with Adtran.
