05-01-2007 04:47 AM - edited 03-14-2019 09:14 PM
Hi
I am trying to configure an MGCP transcoder on a 3825 Gateway IOS 12.4(5a) with a PVDM2-64.
CCM is 4.1
Could anyone be so kind as to post a "Step by Step" guide as to how to do this ?
From a MRGL point it needs to be available to all users but only perhaps half a dozen at a time
Thanks.
05-01-2007 04:52 AM
The link below should give you the ste by step instructions on how to configure transcoding on an IOS router.
http://www.cisco.com/en/US/products/ps6441/products_configuration_guide_chapter09186a0080541bf3.html
05-01-2007 10:21 AM
If you want a shortcut, here is my config:
voice-card 0
no dspfarm
dsp services dspfarm
!
sccp local Loopback0
sccp ccm A.A.A.A identifier 1 version 4.0
sccp ccm B.B.B.B identifier 2 version 4.0
sccp ccm C.C.C.C identifier 3 version 4.0
!
sccp
!
sccp ccm group 1
associate ccm 1 priority 4
associate ccm 2 priority 2
associate ccm 3 priority 1
associate profile 200 register MTP001122334455
!
dspfarm profile 200 transcode
codec g711ulaw
codec g711alaw
codec g729ar8
codec g729abr8
maximum sessions 12
associate application SCCP
no shutdown
!
To verify:
#show dsp dsp all
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide