02-16-2009 01:55 AM - edited 03-15-2019 04:14 PM
I see from RTMT that TranscoderResourceAvaible is 6
Is it possible increase this number?
02-16-2009 04:59 AM
Any answer?
02-16-2009 07:22 AM
yes, configure more sessions on your XCODER
it's pretty obvious
HTH
java
if this helps, please rate
02-17-2009 01:05 AM
If I increase this parameter, will everything work fine?
Isn't XCODER sessions depend on other voice services?
I suppose that If I increase XCODER session, something else begin work worse?
Can you explain this step in more detail or give needed link?
thank you!
02-17-2009 06:21 AM
It depends on your available PVDMs in the router (hardware), to increase it you need to have them. The router will tell you if you do or not when you go to re-configure them.
HTH,
Chris
02-17-2009 07:45 AM
i assume you think this is configured on the CUCM server, NO. this is configured on ISRs with PDVMs, and won't cause anything to work worse
HTH
java
if this helps, please rate
02-17-2009 11:03 AM
I understand the procedure of configuration XCODERS.
How many XCODERs can configure on CUCM, as I understand this XCODERs are used by MRGL -> Device Pools.. so only 1 XCODER can work at a time?
An other question: to configurate fault tolerance should I configure second XCODER?
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide