Transfer From IP Phone to FXS.

[angecarl1]

                   I have a home lab setup with a couple of 7940s, 7960s, 7920s and also one FXS for my house phone with an FXO.  I cannot get my IP Phone to transfer calls to my house FXS.  I can transfer calls from my analog phone to IP phones though. Thanks in advance for the help. Attached is my full current config.

[Chris Deren · Accepted solution]

You don't have any transfer-patterns defined under telephony-service, try adding one matching your internal DN range.

HTH,

Chris

[angecarl1]

OK, I added transfer-pattern 1... and it lets me dial 1100 which is my analog phone, but I get Busy in my display and hear the busy tone.   What is going on now?????  thanks

[angecarl1]

Thanks for getting me correct answer, I have finally figured it out.  The ephone buttons I had were wrong and under CLI sh stcapp dev summ was showing my FXS registered as my home phone number and not there DN number.  Thanks