IP Telephony and Phones

HI I have resently upgraded my cme to 8.8 & ios version isc2900-universalk9-mz.SPA.152-1.T2.binafter that on wards i am haveing problem .from the cme setup we will dial a  speed dial and the call is routed to ccm translation patten and  from the ccm ...

Hello!Am running a UC520 box. Registered endpoints include CIPC and 7942 IP Phones. Cisco Unified Video Advantage is enabled for all the endpoints. Sometimes video shows but sometimes the calls are voice only. My client is getting frustrated because ...

Hi all,I have a small problem. Recently I setup CUVA (2.1.1) for testing with our CUCME (8.6) and couple IP phones (Cisco 7960G running newest firmware & SCCP). When I run CUVA with IP communicator everything is working fine (video, audio etc) is wor...

Hello! I'm running CIPC 7.0.2.0. I want to know how I can make it auto start with Windows because some of my users do forget to run the program. I have looked around the prefences menu and failed to find something linked to that.Thanks in advance.Kel...

Hi, could someone clarify whether any DLU's are required when adding a VG224 and analogue phones? There seems to be some confusion with some people saying you do need DLUs when using SCCP?If anyone could confirm one way or the other it would be much ...

why CUBE is not transparently sending in incoming ringing(180) with SDP to an outgoing ringing(180) with SDP?Regards

Hi All,Basicly, i need to get MAC address of the Hardphone from the PC which phone is connected.I guess it should be somewhere in registry but i couldnt findThanks in advance

Hi All,Let me explain our needs.We have agents who have PC Client(Cisco IP Communicator) or hardClient( CiscoIP Phone  which is connected to PC) or both of them. We need to get all InstrumentID of the phones on that PC (Soft and hard phone). I heard ...

I have an ICT connection that started to give me call troubles.From my troubleshooting i found this error, every time i make a call:01/16/2012 14:20:43.781 CCM|MmmanService - ERROR Too many calls to decrementTotalNumberOfRegisteredCallingEntities, Al...

Hi All,I have a 39XX router as cme and cue (40 phone regiter it). That router is just connected to PSTN. So At this point I think that I dont have to make media resource configuration like blow. am I right ? or Which configuration should I make. I wi...

Hi all,I have to configure an FXO line for 999 calls. okay this works fine when i am in SRST mode and I have application global alternate default ON with dial-peer voice 999 pots description EMERGENCY destination-pattern 999 port 0/1/0 forward-digits...

                   I just set up a two 7940 SIP phones. Ive been trying for days to receive/send calls with no luck.I am using a CISCO 1760 router and I have installed a 4.3 CME version. I configured the phones according to many of the postings and I...

we have a CUCM 7. integrated with a Nortel PBX. FAC was enabled in CUCM and works well in cisco phones, phones, however the Nortel PBX can not dial when asked the code (fac). Any ideas?, Please, thanks

Hi Guys,I have a problem with some calls. When we try to call (PSTN to IPTel) the calls are direclty disconnect (not all some works, and some don't work)In the SDI traces I have the following:|3,100,152,1.894691^10.187.38.8^*17:26:37.065 |<MN::MGCPEn...