03-08-2010 12:28 PM - edited 03-15-2019 09:41 PM
Experts,
I have a remote site that is EZPVPN'd into the UC520 using a Cisco 861. The tunnel is up and running as expected. The 7921g registers and works as you would expect after it has been turned on. The problem comes in when you leave it idle, after a minute it seems like it loses connectivity to the UC520, but if the phone is left to itself, it will re register and work, then go "offline" again.
It is connected to a non Cisco AP at the moment. Could this be the issue? What else could be causing this to happen when connectivity is solid? Also a ping to the office gateway fromthat remote site is between 10ms and 40ms.
Brian
03-08-2010 12:36 PM
is 7921 Fw the very latest ?
debug ephone keeplaive shows anything ?
03-08-2010 12:51 PM
The debug shows it registered with no errors.
03-08-2010 12:59 PM
I noticed the keepalive is only at 2...compared to the hundreds or thousands for the other 7921's in the local site...any ideas?
03-08-2010 01:04 PM
Update FW as necessary to begin with.
03-08-2010 06:05 PM
Resolved myself. Issue was not with Wifi. QOS was configured properly.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide