Unknown WIC in slot(0/0), wic card has an unknown id of 0x51
have a problem with a Cisco 2911/K9 with 1 x PVDM2-16 + the PVDM adapter and 2 x VIC2-BRI-NT/TE. This should be a supported combination.
We see the cards when doing a sh diag, but they do not appear at all when doing sh run, in fact no voice conf is shown at all. We can not for example see any voice ports and we can not issue the voice commands etc,
We have the proper UC license activated and it shows as active when doing sh lic
In the log we get Unknown WIC in slot 0/01, wic card has an unknown id of 0x51.
IOS is c2900-universalk9-mz,151-4.M5.bin
I can not find that this IOS should be incompatible.
I know it's an old post but I had the same issue and could not find the resolution on this post.
The fix for me was to enable uck9 license on my Cisco 2911 router.
Ensure it's permanent.
I used IOS version : c2900-universalk9-mz.SPA.155-3.M7.bin"
PBX-01#show license Index 1 Feature: ipbasek9 Period left: Life time License Type: Permanent License State: Active, In Use License Count: Non-Counted License Priority: Medium Index 2 Feature: securityk9 Period left: Not Activated Period Used: 0 minute 0 second License Type: EvalRightToUse License State: Active, Not in Use, EULA not accepted License Count: Non-Counted License Priority: None Index 3 Feature: uck9 Period left: Life time License Type: RightToUse License State: Active, In Use License Count: Non-Counted License Priority: Low
RTMT alert are triggered when the services configured to collabaration servers. Some of the alert are triggered while triggered from the alert. Voice and Video AlertsThe following list comprises the preconfigured Voice and Video alerts:• BeginTh...
Cisco Champion Radio · S7|E46 From Efficiency to Resiliency with Cisco IT
The COVID-19 pandemic set a new high bar for organizations and their need for increased business resiliency. When the pandemic hit, thousands of organizations around the world foun...
Hi,I'm facing problem while trying to login Cisco Prime License Manager. When I type login and password it show me “Invalid Username or Password. Please try again.”. But login and password correct. I reset password but it is show the same error. &nbs...
Hello everyone,after updating the CUCM to the last version 18.104.22.16800-97 a customer complains about errors on an applications server. These errors did not occur before the update. Phones can no longer be controlled. Only after a reinitialization of the ...
Hello, We have been facing issues with backup of drfcomponent.XML & Processnode.XML files to our backup servers during scheduled Backup in our CUCM 11.0 servers.We have been using Titan FTP server for Backup. I see error on backup statusERRO...