Upgrade File from CUCM 6.1 to CUCM 8.5

[matthewlogan46]

Hi,

I am doing an upgrade. I'd like you to confirm me if the following files for installation are correct:

Active partition: 6.1.2.1000-13
File to Install: UCSInstall_UCOS_6.1.5.10000-10.sgn

Inactive Partition: 6.1.2.1000-13
Active Partition: 6.1.5.10000-10

File to install: UCSInstall_UCOS_8.5.1.10000-26.sgn

Inactive Partition: 6.1.5.10000-10
Active Partition: 8.5.1.1000-26

Are those all file to complete the upgrade from 6.1.2 to 8.5.1?

The file: ciscocm.allow_upgrades_to_unrestricted.cop.sgn, is necesary?

Thanks!

[Chris Deren]

Is there a reason you want to go to base 8.5.1 vs. 8.5.1SU4 for example? It would take the same amount of effort.

Check out compatibility matrix for supported upgrade paths:

http://www.cisco.com/en/US/docs/voice_ip_comm/cucm/compat/ccmcompmatr1.pdf

Why would you want to go to unrestricted version? What country are you in?  Most typically installations are Restricted unless you cannot use it because you are in a contry that Cisco does not allow it.

HTH,

Chris

[matthewlogan46]

Thanks Chris.

About the version there is no particular reason. My country is Chile.

[Chris Deren]

You should not need unrestricted version in Chile, so no need to run the cop file.

Chris

Sent from Cisco Technical Support iPhone App

[matthewlogan46]

Thanks Chris.

[Chris Deren]

Matthew,

Did you require further assistance hence the low rating?

Chris