10-12-2008 06:15 PM - edited 03-15-2019 01:53 PM
I have a UC500 with two 4-port FXS cards. The 4 ports on the first card were automatically setup and ephones were configured using the MAC address of the first card. Now I want to use the FXS ports on the 2nd card but I don't know how to get the MAC addresses for the second card. When I do "sho stcapp device summ" I only see the first four ports. What do I need to do here?
Thanks,
Diego
10-12-2008 10:59 PM
with FXS ports u dont need any mac address and even done need ephon !!!!
can u post ur config
fxs for analog phones
if u have fxs port 0/0/0 connected to analog phone and u want to give it ext. number as 333
u need pots dial-peer as following
dial-peer voice 9 pots
destination-pattren 333
port 0/0/0
good luck
10-13-2008 07:37 AM
I understand that it will work. However, I want to use the DN and ephone for consistency with the other analog devices. You also get internal caller-id and the extensions are logged in the directory.
Thanks,
Diego
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: