Hey All,
Wanted to run this by my peers to see if this is doable or not. Basically I have a centralized cluster with multiple CUCM groups (between an 8 node geo-cluster) and I am trying to figure out if the following is possible. With Local Route Groups (LRG) you create one route group and one route list. The problem is that if I can only use one route list then I have no choice but to use the one CUCM group that is configured in that route list. Is there no way to use a route list with another CUCM group configured? The problem I am trying to avoid is using one route list that is tied to one CUCM group and have 90+ remote sites use that one CUCM group. Trying to keep the load spread over the cluster.
Please let me know if this doesnt make sense and I will try to clarify.
Thanks!
