Valcom 2001a on UC540

[homelandsecureit]

I have a UC540 setup using the CCA. i also have a Valcom 2001a for overhead paging. Can someone please tell me how to config this in the CCA? i have found post about the UCM but that does not help me.

Thanks                  

[testeven]

Hi,

You can refer to this document, it might help:

https://supportforums.cisco.com/docs/DOC-9776

Regards, 

Tere. 

If you find this post helpful, please rate!

[homelandsecureit]

Thanks for the response, however, this is a new system being installed with NO door opener. what i need is a step by step on how to configure the overhead paging system in the CCA for use on the UC540.