All - I am trying to get a Valcom multi zone paging system to work. I currently can page all zones but can't page each individual zone. If I connect a butt-set to the Valcom, I can page each individual zone by pressing 0 for all, 1 for warehouse and 2 for office.
I created a dial-peer, and a 329008 route pattern. Port 1/0/0 is a FXS port.
When I dial 329008 it just pages all. It seems to acknowledge when I press 0 or 1 or 2, but it doesn't do anything.
dial-peer voice 999100 pots
description 329008 Paging
preference 1
destination-pattern 329008
port 1/0/0
Any suggestions would be appreciated!
Thanks,
Jaime
