05-27-2008 02:51 AM - last edited on 03-25-2019 07:41 PM by ciscomoderator
Trying to configure a Port on a VG224 (12.4-15(T5) on CCM 4.13(Sr7) for faxing - when dialing from the fax machine the caller ID shows âunknown numberâ you can fax from it but unable to receive faxes to it. I've reboot the CCM associated to this VG, shut and un-shut the voice port, moved to another port on the VG with same results. I can see the number hitting the voice gateway (3845) but doesn't ring the fax machine or when using a butt set on the line. I've seen this before on another VG224, rebooting the CCM fixed that one but not this one - any help is greatly appreciated.
Jim
06-02-2008 10:52 AM
The problem is with the fax traffic getting from your main gateway to the VG224, it is not an issue with traffic from the VG224 towards the main gateway. Most common reason this happens - clock slips on the PSTN gateway digital trunks. Assuming you have some kind of T1/E1 gateway, do a show controller
network-clock-participate t1 wic 0
network-clock-select 1 t1 0/0/0
this will recover the clock signal off the PRI on controller e1 0/0/0 and use it to drive the DSP's and the traffic in the TX direction, so there will be a common clock reference system wide and the slips should be cleared.
06-09-2008 10:19 AM
Thanks - I'm using a 3845 with FULL DSP resources, did the show controller and didn't have any slip indications, I found if I shut and unshut the port - eventually the number will be usable, not sure what causing it.
Jim
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide