cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
285
Views
0
Helpful
4
Replies

VG248 swap out

rcrumm_2
Explorer
Explorer

What do I need to do to swap out a VG248?

I conigures the IP address etc.., enabled the ports

Do I just configure the GW MAC address in CM and/or do I need to go into each DN and change the MAC as well?

Thanks,

Randall

1 Accepted Solution

Accepted Solutions

Rob Huffman
Hall of Fame Community Legend Hall of Fame Community Legend
Hall of Fame Community Legend

Hi Randall,

Have a look at and make note of the specific settings on the VG (via console or telnet) before doing any changes. When you are ready you can go to the Device>Gateway Page on CCM and and change the MAC address from old to new and reset. You won't need to change the MAC for all the individual ports.

Hope this helps!

Rob

View solution in original post

4 Replies 4

Rob Huffman
Hall of Fame Community Legend Hall of Fame Community Legend
Hall of Fame Community Legend

Hi Randall,

Have a look at and make note of the specific settings on the VG (via console or telnet) before doing any changes. When you are ready you can go to the Device>Gateway Page on CCM and and change the MAC address from old to new and reset. You won't need to change the MAC for all the individual ports.

Hope this helps!

Rob

Thanks Rob,

That is what I thought. Just wanted to make sure.

Randall

Rob Huffman
Hall of Fame Community Legend Hall of Fame Community Legend
Hall of Fame Community Legend

Hi Randall,

You are most welcome :)

Take care,

Rob

Hi Randall,

I run the program in CM4.1(3) Pubscriber, it display"unable to locate mscoree.dll".

What CM version you are using? What stepes we use that program? please show us more information in details, thanks in advance!!!

Michael.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Recognize Your Peers