cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
864
Views
10
Helpful
8
Replies

Voice over IP - VPN problem

Hello all, i have the following scenario :

picture.jpg

My problem is :

1. I have IP communicator on the 10.20.50.0 network that i want to register with a VPN tunnel. I create a tunnel to the ASA5505 and when i try to ping the

10.20.100.0 network, there is no problem, but when i try to reach the other two - 10.10.100.0 and 192.168.100.0 i can't. There is a trunk between the 3945 and the netgear switch. Do you have any ideas what should i do to connect to the 10.10.100.0 network? Thanks

1 Accepted Solution

Accepted Solutions

Hi Svetoslav.

Can you please post your ASA config to help you to modify it accordingly?

Thanks

Regards

Carlo

Please rate all helpful posts

"The more you help the more you learn"

Please rate all helpful posts "The more you help the more you learn"

View solution in original post

8 Replies 8

any ideas friends?

Hi Svetoslav.

When you are connected with vpn client, which are secured routes that you receive from ASA.

Let me know

Regards

Carlo

Please rate all helpful posts

"The more you help the more you learn"

Please rate all helpful posts "The more you help the more you learn"

Sorry friend , i don't get it where can i check it ?

Hi.
I was asking for secured network received by you client once you are connected.
If you are using anyconnect you can see it through statistics window and secured route tab.


HTH

Regards

Carlo

Sent from Cisco Technical Support iPhone App

Please rate all helpful posts "The more you help the more you learn"

hello friend, i'm using cisco vpn client and in secure routes i see only 10.20.100.0

Hi.
That's why you cannot reach other networks.
Please contact your security administrator and ask him to modify your profile to allow you to reach all other subnets.

HTH

Regards

Carlo

Sent from Cisco Technical Support iPhone App

Please rate all helpful posts "The more you help the more you learn"

Thank you for the answer, but i should allow the profile to connect to the netrorks... I allow all inside networks but it only gets access to 10.20.100.0

Hi Svetoslav.

Can you please post your ASA config to help you to modify it accordingly?

Thanks

Regards

Carlo

Please rate all helpful posts

"The more you help the more you learn"

Please rate all helpful posts "The more you help the more you learn"