09-22-2021 07:04 AM
Hallo,
I have a WS-C3750X-24P version 15.2(1)E1 switch that I am trying to run IPv6 in VRF but I get the following message 'IPv6 VRF not supported for this platform or this template'.. I have used the 'mls ipv6 vrf' command but an error occurs '% Invalid input detected at '^' marker.'
R1(config)#mls ipv6 vrf
^
% Invalid input detected at '^' marker.
R1(config)#
Any help will be highly appreciated.
Solved! Go to Solution.
09-22-2021 03:14 PM
Hello,
There are a few prerequisities before you can enable IPv6 support on a Cat3750X switch:
After meeting both these conditions, the switch should support IPv6 and you should be able to enable it using ipv6 unicast-routing and then configuring the IPv6 features as usual. Note, "mls ipv6 vrf" is a non-existent command on this platform. The proper way of creating an IPv6-enabled VRF is through vrf definition and the address-family ipv6 inside it.
Best regards,
Peter
09-22-2021 03:14 PM
Hello,
There are a few prerequisities before you can enable IPv6 support on a Cat3750X switch:
After meeting both these conditions, the switch should support IPv6 and you should be able to enable it using ipv6 unicast-routing and then configuring the IPv6 features as usual. Note, "mls ipv6 vrf" is a non-existent command on this platform. The proper way of creating an IPv6-enabled VRF is through vrf definition and the address-family ipv6 inside it.
Best regards,
Peter
09-23-2021 12:22 AM
Hallo Peter,
This was very very helpful. Thank you very much. Everything works well now.
09-23-2021 06:07 AM
Hello,
You are welcome! : ) I am glad to hear it is working now!
Best regards,
Peter
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide