While using Packettracer 7.3 version. I was not able to configure ospfv3 into any of the given router. R1(config)#router ospfv3^% Invalid input detected at '^' marker. i get this message in every router. I try to search and try it in every router th...
I had a strange discovery recently that I have tested a little today. Is this a bug or do I need more configuration to make this work? I have a client connected to a switch (IE2000) that is again connected to a router with a trunk, and this router ha...
I have several site to site VPN configurations created on the RV160 router that are working fine. They are all built utilizing IPv4. What I want to know is if it is possible building these site to site VPN connections utilizing IPv6. I don't see an...
Hi all, this sounds like a simple question. Can anyone help? Thanks.
I cannot seem to get a basic NAT64 configuration working on a Cisco 4321. The config has been reset; and only the following changes: ipv6 unicast-routing!interface Loopback0 ip address 8.8.8.8 255.255.255.255!interface GigabitEthernet0/0/0 descripti...
What is included in this RMA?Does CPU, PSU and RAM included or not. What do more parts do I need to make the UCS server complete when I get it.RMA Part id: PI-UCS-APL-K9: Cisco Prime Infrastructure UCS Physical HW Appliance
Hello,I'm trying to get familiar with PPP IPv6 using SLAAC (and later DHCPv6).So I set up a very simple GNS3 lab with two C2691 IOS images (old but it should be enough):I'm using a serial link so that I do not need the PPPoE configuration items (BBA ...
Hello all, I'm a little confused on iBGP and IPv6. Here is our setup: We have a Nexus 3000 which houses our VLANS and serves as our layer 2 device. Our eBGP sessions are on a Juniper MX960. We want to start routing our IPv6. I've done BGP for IPv4 an...
Hey,maybe someone else has a similar problem. ISP(dynamic v6 Prefix) <=> ASA <=> Routernow: ASA as DHCPv6-Client , router uses "ipv6 general-prefix"future: ASA as PD-client and DHCPv6 service with delegation for the router ASA(config)#ipv6 dhcp pool ...
Hi, I have a SG250-26 release 2.5.0.90 and I am facing an IPv6 deployment problem.I've build an IPv6 SLAAC & stateful router on Pfsense, but the communication between devices through the switch is not working.I can see RA and RS in and out of the swi...
Hi, When i ping from pc it says request time out. PC is connected to switch and switch is connected to router. I can ping to other PCs which are connect to the switch and its getting reply. only issue is when i ping router it says request time out. A...
how to Redirect a public IP address to a private webserver port 80 ?????
Hello, I was wondering, if someone could please take a look at the attached config including logs.Basically, I wanted to set up a simple dhcpv6 topology:dhcpv6 RTR----Relay----Client. For some reason client does not receive DHPCv6 address. At dhcpc6...
I'm trying to learn more about IPv6 but with the huge amount of information out there, I'm having trouble even coming up with the terminology to search for my issue with.My ISP provides me with a dynamic /48 through prefix delegation and I'm trying t...
Hi everyone I'm studying cisco as a self-taught I came to subnetting. By doing an online exercise, the following happened to me:What are the subnet mask, first available host address of subnet one (NOT subnet zero), and the maximum number of hosts pe...
.jpg "VIP Advisor"){kind=icon}
