Assign IPV6 To VPCS in GNS3

[hfakoor222]

So I am able to get SLAAC working on my VPCS : Output PC2

here is topology

However I cannot normally set a default gateway using standard VPCS command

PC2>  ip ipv6Address/64 (this works)

this is link address for my interfaces on my router FE80:C002:6FF:FE81:0

PC2>  ip ipv6Address/64 FE80:C002:6FF:FE81:0

The above command assigns no default gateway.

Any suggestions?

[hfakoor222]

I believe I fixed it I was applying the wrong link address to the command

am i correct in assuming the below output means that this works?

[Harold Ritter · Accepted solution]

Hi @hfakoor222 ,

This output means you can ping the router link local address. I think your default gateway is configured properly, as the "show ipv6" output shows the router link layer address. You should try pinging a remote destination to see if it works properly.

Regards,