06-04-2015 03:42 AM - edited 03-01-2019 05:47 PM
what cisco hardware support NAT64 configuration ??
06-05-2015 12:20 AM
Hi there,
Stateful NAT64 is only supported on ISR4300/4500 and ASR/CSR1000 routers.
cheers,
Seb.
06-08-2015 10:57 PM
Hi Seb,
Thanks for your quick response.
I have done some research & found ASA with 9.1.1 will help me achieving the same.
Cheers,
Parmanand Patil
06-09-2015 02:03 AM
Hi Parmanand,
You are right the ASA does support NAT64, but it is stateless. For each IPv6 address you will need a corresponding IPv4 address. You will likely need a large pool of private IPv4 addresses to NAT into, these in turn, if requiring internet access, will then need to undergo stateful IPv4 NAT. NAT'ing traffic twice will require a little bit more effort to audit.
cheers,
Seb.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: