Ipv6 configuration

[ket14pril14]

Hi everybody, I have been trying to configure router using ipv6 via CLI. Despite my input matching one suggested in the official documentation, CLI has marked all the inputs as invalid. I am using Cisco Packet Tracer 8.2.1

Here are examples of my inputs

I will be grateful for any suggestions on what could have gone wrong or ideas on how to configure ipv6 successfully

[Martin L · Accepted solution]

Try ipv6 unicast-routing command in global mode (required for ipv6 to run) or try different router; PT is just a simulator based on IOS but it is not real IOS; some things may work while other commands and technologies are missing; (some tech is adopted for PT)

Regards, ML
**Please Rate All Helpful Responses **

[ket14pril14]

Thank you so much! Your answer was a really great help

[syaifulnizamshamsudin]

Thank you