cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
2525
Views
0
Helpful
2
Replies

ISR1101 static ipv6 on cellular interface

torles
Level 1
Level 1

Hello !

I try to configure a static ipv6 address on the Cellular interface and get the following error message:
"Can't add negotiated ipv6 address".

Error message is also on an unconfigured Cellular interface !

 

(Cisco IOS XE Software, Version 16.09.08)


interface Cellular0/2/0
no ip address
load-interval 30
dialer in-band
dialer idle-timeout 0
dialer-group 1
ipv6 enable
pulse-time 1
end

 

Every time a new connection is established, the cellular interface gets a new ipv6-address from the provider.

I can not see any configured negotiation !

 

Is there a solution for the problem ? Thanks !

1 Accepted Solution

Accepted Solutions
2 Replies 2

marce1000
VIP
VIP

 

       - FYI  : https://bst.cloudapps.cisco.com/bugsearch/bug/CSCvw91915

 M.



-- Each morning when I wake up and look into the mirror I always say ' Why am I so brilliant ? '
    When the mirror will then always repond to me with ' The only thing that exceeds your brilliance is your beauty! '

torles
Level 1
Level 1

Review Cisco Networking for a $25 gift card