Using IPv6 hosts in IPv6 ACL

[shaijosef]

Hello Cisco experts.

While working with Cisco router with IOS  12.4(25b) I noticed that

I can configure  "ipv6 host" that can contain multiple ipv6 addresses,

I would like to use it in ipv6 acl but it seems that I can't.

Is there syntax or IOS version that allow me to use "ipv6 host" in ipv6 acl?

thank you

[lgijssel · Accepted solution]

Yes you can. ;-)

In this link is the syntax described to use a host as source or destination in an acl:

http://www.cisco.com/en/US/docs/ios/ipv6/configuration/guide/ip6-sec_trfltr_fw.html#wp1072522

regards,

Leo

[SunilKhanna · Accepted solution]

Hello Josef,

Here is another configuration example

IPv6 Traffic Filtering Access List Configuration Example

Regards,

Sunil.