Hi folks,
Is there a way to relate the PortState referred to a remote MEP in CFM, to an action on the state of the port, instead of sending a trap?
I tried the cfm between three switches, and in the example the show of the remote MEP.
7600-tp#sh ethernet cfm maintenance-points remote
-------------------------------------------------------------------------------
MPID Level Mac Address Vlan PortState InGressPort Age(sec)
Service ID
-------------------------------------------------------------------------------
400* 4 001d.a28e.7e00 4 UP Gi4/19 4
service-vlan
Is there a way to put in shut the gi4/19 of the example, when the portstate is DOWN or ADMINDOWN?
Thanks.
