cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1446
Views
0
Helpful
3
Replies
Highlighted
Beginner

ME3600X PPPoE Intermediate Agent

Hi guys,

I'm trying to insert pppoe vendor specific attributes (circuit-id/remote-id) into subscriber traffic.  The device that I would like to implement this on is the ME3600X Metro Ethernet switch.

I've found a config guide for the ME3400 switch that outlines how to configure the switch as a PPPoE Intermediate Agent but none of the commands are valid on my ME3600 platform.

I've also found the config guides for setting up DHCP Snooping and modifying/inserting the circuit/remote ID fields in the Option 82 fields however I cannot use these fields to authenticate subscribers based on my BNG & radius combo - it must be PPPoE.

Any suggestions?

3 REPLIES 3
Highlighted
Beginner

ME3600X PPPoE Intermediate Agent

PPPoE IA is not supported on ME-3600.

Where did you see the support document which mentions you can configure it on ME-3600 ?

Highlighted
Beginner

ME3600X PPPoE Intermediate Agent

Hi Yasir,

Thanks for your prompt response, it appears that you are correct.

I haven't seen any documentation stating that the ME-3600 supported PPPoE IA. 

The reason I asked this question is that I did find documentation for the ME-3400 using PPPoE IA.  This and the ability of the ME-3600 to do circuit ID / Remote ID insertion for DHCP option 82 made me think that perhaps I was just missing the documentation for the ME-3600.

Can I ask what documentation you used to definitively say that the ME-3600 does not support PPPoE IA?

Cheers,

Highlighted
Beginner

Re: ME3600X PPPoE Intermediate Agent

hi yashfaqu,

what about the Nexus3000 C3064PQ??
do you know that Nexus 3000 support PPPOE Intermediate Agent or not???

 

Thanks
mahdi

Everyone's tags (1)
CreatePlease to create content
Content for Community-Ad

Cisco COVID-19 Survey

This widget could not be displayed.