NCS 520 service instance trunk configuration

[Adcom911]

Hello,

Looking for some help on this trunk config I maybe don't understand the service instance configuration on a Ncs 520 but I'm unable to see the other N520 connected to this device with these configs plugged into each other. Please let me know what I need to fix or change to get the trunk up. Thanks in advance! 

interface GigabitEthernet0/0/0
description To-N520-1
no ip address
media-type rj45
negotiation auto
cdp enable
service instance 10 ethernet
encapsulation dot1q 1-4094
!

interface GigabitEthernet0/0/0
description To-N520-2 
no ip address
media-type rj45
negotiation auto
service instance 10 ethernet
encapsulation dot1q 1-4094

[Ramblin Tech]

Trunk EFP config aside, does CDP see the link neighbor on both ends? If that is not happening, then there is something else going on.

[Adcom911]

Yea, I saw that was a problem with CDP not enabled globally. I did on both and still not seeing each other. When I get in tomorrow im gonna try a different cable just to see.