I am wondering if anyone has seen the same issue I have on several ASR 100x-X series routers when issuing a reload command from the console port to reload the device. I am dialed in via PSTN/modem and issue the reload command, but 1) the RP/Router never reloads, (I never see any informational messages like you would when a router reloads).
2) the device is still pingable, but is not accessible via telnet or ssh.
Am I missing something or shouldn't the router/RP actually go through it's reload cycle and come back up?
cvn-rjkrm01#sho inventory
NAME: "Chassis", DESCR: "Cisco ASR1002-X Chassis"
PID: ASR1002-X , VID: V05, SN: FOX2016G0W1
NAME: "Power Supply Module 0", DESCR: "Cisco ASR1002 AC Power Supply"
PID: ASR1002-PWR-AC , VID: V04, SN: DCB202140EN
NAME: "Power Supply Module 1", DESCR: "Cisco ASR1002 AC Power Supply"
PID: ASR1002-PWR-AC , VID: V04, SN: DCB201540MT
NAME: "module 0", DESCR: "Cisco ASR1002-X SPA Interface Processor"
PID: ASR1002-X , VID: , SN:
NAME: "SPA subslot 0/2", DESCR: "2-port T3/E3 V2 Serial Shared Port Adapter"
PID: SPA-2XT3/E3-V2 , VID: V01, SN: SAL1938PDWQ
NAME: "SPA subslot 0/0", DESCR: "6-port Built-in GE SPA"
PID: 6XGE-BUILT-IN , VID: , SN:
NAME: "module R0", DESCR: "Cisco ASR1002-X Route Processor"
PID: ASR1002-X , VID: V05, SN: JAE20190292
NAME: "module F0", DESCR: "Cisco ASR1002-X Embedded Services Processor"
PID: ASR1002-X , VID: , SN:
