MPLS

Hallo @ all, i wanna enable LDP on a device, which is currently only capable for native IP traffic. If i do this, i need to propagte the loopback0 of this device so, that labels are distributed within the backbone. Afterwards, all traffic destined f...

Due to it has many solutions like SSM, Layer 2, mLDP, Nextgen MVPN, etc. Which solution is the best? Thank you very much.

Hello everyone, I'm quite new to mpls so I ask for some guidance from more experienced community members. I'm configuring devices for a small SP, aiming at delivering L2/3VPN for customers, using MPLS. Network consists of three routers: R1, loopbac...

Please refer the attached exhibit and let me know what is the real significance of Route distinguisher in a MPLS core. Router sitting in middle is a vpnv4 RR and all the PE's are client to the Vpnv4 RRWhats the significance of RD in PE4.How the prefi...

Hi everybody,  I have been reading  " MPLS FUNDAMENTALS" by Luc DE Ghein. I have a question particularly on QinQ over AToM. Please consider the following scenario: CE1------f1SW1-----MPLS----------SW2f1----CE2 SW1 ( 1.1.1.1) has PW to SW2 ( 2.2.2.2...

Dear Friends, Can anyone let me know if there is a single command to check the delay configured on multiple GRE tunnels on a router. Early response is highly appreciated.

Hello folks, I am at last stage of my MS in Advanced Computer Networks. and I am stuck in finalizing the topic for my dissertation. My area of interest is routing protocols specially BGP. It will be very helpful if someone please give me some exampl...

We have a Verizon MPLS network that we purchased Gold CAR from Verizon.Verizon says the Gold CAR package is for voice only (ef class)My questions is regarding implementing QoS for voice, video and data priority classes.How do I implement the policy?D...

Good morning, I have a problem that is taking my sleep, I had to see if anyone could help me. My xconnect are stopping working by themselves. After a while it works again.Config my cisco. !version 15.5no service padservice timestamps debug datetime m...

Please I want to know that book or link I can to see about this point , because i need to size network about ISP. we are start to offert internet service with ftth. • Number of simultaneous DHCP IPv4 / IPv6 sections • Automated provisioning of sub...

Hi there, I would like to confirm that it is not possible to configure mpls within a subinterface that belongs to a VRF. Is it because MPLS is layer 2 and VRF is layer 3 concepts? Configuration should look like this: interface FastEthernet1/0.3010 de...

Hi Guys, I have a setup (2 PE - 2 CE. Image attached). VPNv4 eBGP is configured between PE & CE. I have access to only CE's. I am receiving routes in VRF's from PE via eBGP. Then its advertised to other CE via VPNv4 iBGP (No MPLS configured).  Now ...

Hi, My topology is like this : PE(A)-----PE(B)----Totally Stub Area 2 ----PE(C)------Area 0------PE(D)------Area 1------PE(E)----FEC(1.1.1.1) LDP is running on all the nodes. At PE(A) i want to create a NON-TE LSP for 1.1.1.1 I have a MPLS LDP C...