Cisco 3925 with ethsw module EoMPLS support

[lee.reade]

Hi,

I am looking for clarification that the ethsw module, NM-16ESW, will not allow for EoMPLS support?

From what I have read on CCO it seems to suggest that the EHWIC-4/8ESG is needed to support this?

Basically, I had 15.2(4)M1 on my 3925, but none of the EoMPLS VC's would come up for the vlans that were attached to the ethsw module.  Other EoMPLS VC that used onboard gig ports came up just fine.  All LDP signalling/routing is correct.

Can anyone provide any confirmation?

Thanks,

LR

[Reza Sharifi]

Hi,

The switch (NM-16ESW) inside your router runs an image for the 3560 switches and the 3560 switches don't support MPLS.  They only support vrf Lite.

HTH